Robots

• My LEDs and/or Buzzers aren't reacting!

• Your cable is inserted upside-down.
  Solution

  • Check page 02 of the Icon Programming Environment Manual or page 02 of the Icon Programming Environment Guide (Part 01) to see how your cables should be plugged in.

• Your connector may not be assigned properly.
  Solution

  • Check that your Port Settings match the connectors on your Studuino and that your program is using the correct connector numbers.

• Programs such as those shown here will run without any reaction from your LEDs and Buzzers.
  Solution

  • Insert a wait 1 sec. block and check to see if your LEDs and Buzzers are working.